Page 1 of 1

Connection and Property in single panel

PostPosted: Fri Aug 26, 2011 3:14 pm
by oxoocoffee
Would it possible to configure so properties can be in the same panel then connections?
I know I can drag one on top of the other but when I pin one of them so it "hides" they undock from each other.
This makes configuring each option little painful since I have to switch between them.
All I wan to have is hide Connection panel and have properties in there too since it makes sense. If that bother someone you can just snap
properties to bottom or uses can resize it using spliter. This way if I go over connection when it is mostly docked/hidden to side of the screen I can get both and both will go away if I loose focus on them.

Re: Connection and Property in single panel

PostPosted: Sun Dec 04, 2011 9:26 pm
by rmcardle
If you drag the properties panel on top of the connections panel, they will merge. You can switch between them by using the tabs at the bottom of the panel.